Home :: How to use :: Contact :: Alliance Designer Products
Gator Dust Bond : Polymeric Stone Dust
How to Use Polymeric Stone Dust
- Install natural stones on crushed stone bedding that is well compacted.
- Sweep Gator Dust Bond in between the natural stone joints.
- Hit the natural stones with a rubber hammer; this will make Gator Dust settle firmly into the joints by removing air pockets.
- Sweep off all excess Gator Dust on the natural stone surface. Ensure that Gator Dust lies 3mm (1/8") below the top of the paver (repeat step 3 if necessary).
- Direct a fine mist of water in the air to dampen all the Gator Dust joints. Dampen until there is water retention on joints surface (45 seconds).
- Minimize or avoid, if possible, walking on the natural stones for 24 hours after the installation of Gator Dust.
PLEASE NOTE : Gator Dust Bond hardens like concrete and will crack if the crushed stone base has movement.
| NEVER USE POLYMERIC STONE DUST WHEN PAVERS ARE INSTALLED ON A CONCRETE SLAB. GATOR DUST BOND MIGHT LEAVE A WHITE RESIDUE IF USED ON CONCRETE PRODUCTS |
Other fine construction materials from Alliance Designer Products
- Supersand Bond - Polymeric Sand
- Gator Block Bond - Polyurethane concrete adhesive
- Gator Nails - 10" Common nails & Spiral Nails, 12" Common Nails